Blendshapes to Verge3d

Hi there Alexander,

Thank you for the quick reply. I have indeed created only one blendshape per object, there are multiple active targets. But Maya does not recognise them as targets until I do “rebuild target” within Maya ; that creates a model of the target. When I had only one target everything worked fine, but since I have created more it has started to load strangely in Verge.

It seems to me that the diffirent targets are influencing eachother. So my target for “Width” is influencing “Angle” target. Those should not be affecting one another.

Please, be my guest!

So if you change the param called “Breedte” (which is width) the model not only changes in the width dimension, but also in angle. Consequently, when the param “Hellingshoek” (which is angle) is at its lowest, it is not at a 10 degrees angle but stuck in a diffirent angle with an unprefferable width.

So my question is actually this: can I create a blendshape system where the width, angle, height etc. are controlled seperately? Now they seem to affect eachother, somehow. This does not occur in Maya itselfs.

Thanks in advance,

Link to the example project file:

P.S. The proper Maya file within the project is “Dakkapel Configurator_Blendshapes”.

Gooday! Has any solution presented itself yet?

I have tried solving this issue within puzzles by creating a “base” morph target without any transformations on it to use as a counter against the other puzzles. But I cannot seem to make it work flawlessly, it always messes up whenever the other parameters are adjusted.